Design W-2830-GK
Features of this design
Operating position: Standing (handle above)
- locks left and right or above
Dimensions
Dimensions | Min. - Max. Inside dimensions in mm |
|---|---|
| X = width | 200,0 - 1500,0 (in 0.5 mm increments) external dimensions: + 21,0 mm |
| Y = height | 100,0 - 400,0 (in 0.5 mm increments) external dimensions(incl. fittings): + ca. 65,0 mm |
| Z = length (Z1 + Z2 + Z3) Z1 = length lid part at the back Z2 = length enclosures part center Z3 = length lid part in front |
75, 100, 125, 150, 175, 200, 225, 250, 275, 300, 325, 350, 375, 400 (in 25 mm increments) |
Note:
In this design (handle above), the dimension Z is always smaller than the dimension Y.
Lid opening types
| Code | lid front Z3 | locks | hinges |
|---|---|---|---|
| 333 | 180° to the left | right | left |
| 334 | 180° to the right | left | right |
Note: Lid front Z2:
This design is only available with a cover opening to the front. Lid Z2 (internal height 25 mm) particularly suitable for installing a front panel
for keyboard, laptop, etc.
Enclosures rear Z1:
In operation, the enclosures Z1 is inclined to about 95 °. Particularly suitable for installing an IPC or display.
| Code | cover rear Z1 | lock | hinges |
|---|---|---|---|
| 155 | Removable to the rear | left and right | - |
| 115 | 95° to the rear, then tilted housing Z2 forward | left and right | below |
| 125 | 120° retractable to the rear, then tilted housing Z2 forward | left and right | below |
| 135 | 180° to the rear, then tilted housing Z2 forward | left and right | below |
Note: Rear cover Z1:
The opening type Code 155, 125 and 135 is very advantageous for the installation of an intermediate flap as an accessory compartment. The opening code code 115 is very advantageous as a service flap.