Plastic Enclosures

Built-on enclosure

Built-on enclosure ABG-1 and ABG-2

Built-on enclosure ABG-1
Built-on enclosure ABG-2

Bouilt-on enclosure ABG-1, H= 13 mm/ 0.51 inch,
Bouilt-on enclosure ABG-2, H=30 mm/ 1.18 inch

These built-on enclosures are enclosures of a special kind. On one narrow side, they have apertures for a connector cable with strain relief pillar and for a 2-pole phone jack. If the apertures are not used, plugs are available. The enclosure can be mounted to the wall without opening it, followed by the covering enclosure. On the bottom, you can find pillars for screwing a circuit board. On the upper side, a tool insert for an aperture is provided.

Internal side of the enclosures

Internal side of the enclosures
Internal side of the enclosures
Internal side of the enclosures

Technical data

dimensions113 x 79 x 13 (or 30) mm
4.45 x 3.11 x 0.51 (or 1.18) inch
materialABS (material change possible)
colorlight gray RAL 7035
black RAL 9005
protection degreeup to IP54 according to EN 60529
explosion protectedon demand
surface resistance4 x 10 (high) 14 Ohm according to DIN 53482
dielectrical strength24 kV/mm according to DIN 53481
flammabilityUL94HB (V0 possible)
circuit board layers2
weightABG-1 ca. 50 g, ABG-2 ca. 70 g
Open/Close
Call us: +49 7081 9540-0

or we call you back:







For information on the use of data entered here.

The request was successfully sent,
we call you back!